Seats are out.

I had the whole evening to myself, and I needed to do something on the car.

First, I stained a very small piece of the Red Oak veneer. I used some "Bombay Mahogany" stain and polyurethane mix. I don't think I like the result. The grain in the Red Oak is very pronounced, and it becomes the focus. There have been several different recommendations to what woods to use, so I just need to find one that meets my expectations.

Second, I tackled the seats. I needed to get at least the passenger seat out, since behind it is where the Megasquirt is going to be mounted. I would never have been able to get the wiring done in the tiny gap behind the seat without taking it out. I took the drivers side out to get everything cleaned up, and so that I could reach another bolt. There is a frame brace that runs tranversely from each seat belt mechanism (in the engine compartment), and I need to cut some bracket off of it for engine clearance.

Last, I ordered the switches from Holden. The exchange rate between America and England is killing me! But once I have these switches, I can get the dash board assembled. I still need to refinish it, but at least I won't be held back by materials. Now I think I have everything I need: the vinyl, some backing material, and the switches. I am sure there are things I am missing, but I am closer to getting it done.